Wooden article to be coated must be dry & free of dust & loose particles. Prepare smooth surface by sanding with emery paper #180 followed by #320 or #400. Cracks if any should be filled & levelled.
Apply one or two coat of WOODPOL Exterior PU clear sealer, depending upon surface smoothness and allow it to dry for minimum of 12 hours. Sand with emery paper # 320 or # 400 between application of successive coat.
Select Finish coat available in Glossy & Matt. Apply one or two coats of GLOSSPOL SUPREME Interior PU – clear and allow it to dry for minimum of 8 hours. Sand with emery paper #320 or #400 between application of successive coats. For better protection apply an additional coat.
» Stirr the contents well before use since soft sedimentation may occur in matt and sealer finish on storage. Strain through musclin cloth in glass or plastic container. Mixing pot, stirrer & spray gun should be free of moisture since system is sensitive to moisture.
» Mix only required amount of Base & Hardner to be used. Do not transfer unused or Left-over material after used into original container as it cause the whole container to gelled up.
» Use within one week after opening Base & Hardner container.
» Since system have limited Pot-life (after mixing Base & Hardner) after which they should not be used.
» Recoating and Hard dry time may be more in case of high humid conditions and/or low ambient temperature.
» Coverage & dry time varies depend on film thickness, quantity of thinner used & nature of wood.
|1||Mixing ratio|| Woodpol Interior PU – Base 80 parts by volume.
Woodpol Interior Interior PU – Hardner 20 parts by volume.
Woodpol Interior Interior PU – Thinner 15 – 30 parts by volume.
|2||Spray Viscosity||15 – 20 secs on Ford cup B4@ 30 °C.|
|3||Maturation time||30 minutes|
|4||Pot-life of mixture||3 – 4 hours at 30°c.|
|5||Method of application||Spraying.|
|Spray Pressure||30 – 40 psi.|
|6||Recommended DFT||30 – 35 microns per coat.|
|7||Drying characteristics @ 30°c & relative humidity below 75%|| Touch-dry 30 minutes.
Dust-free 2 hours.
Tack-free 3 hours.
Sanding-dry 12 hours.
Fully Cured 7 days for solvent &chemical resistance.
|Recoating time||12 hours @ 30°C.|
|8||Theoritical covering capacity @ 30 micron DFT||8 – 10 m2/litre per coat dependent on method of application.|
|9||Shelf life||6 months in unopened condition in original container when stored in cool & dry place, @ 25±5°C.|
|10||Packing||250 ml, 500 ml, 1ltr, 20 ltrs.|
HEALTH AND SAFETY INFORMATION
» Handle products in areas of good ventilation. Avoid inhaling vapours since product contains volatile organic solvents.
» Wear normal protective overalls. Solvent resistant hand gloves, eye goggles are recommended. Avoid skin contact.
» The product is flammable and the container should therefore be kept away from fire & spark or any ignition source.
STORAGE, HANDLING & DISPOSAL
» Store in original container in cool, dry & well ventilated place.
» While handling, avoid inhalation & skin contact. Force ventilation or fresh air mask should be used in confined spaces..
» Disposal in land filing & not in drain or water ways.